Yukon 8P Half Floor: Setup and Care Tips
By Backcountry Hunting Gear and Equipment | Published: 2026-10-26
Category: How-to Guides
Learn how to install and maintain the Argali Yukon 8P Half Floor for your large tent. Get step-by-step setup advice and care tips to extend its life.
Quick answer
Install the Yukon 8P Half Floor by connecting it to the bottom guyout points of your Yukon 8P Tent, then keep it clean and store it dry to maximize its lifespan.
Why use a half floor instead of a full floor
A half floor gives you the option to keep one side of your tent for sleeping on a clean, waterproof surface while leaving the other side open for gear, cooking, or entering without tracking dirt onto your sleeping area. This design reduces weight and pack size compared to a full floor, and it lets you set up a more flexible camp layout.
The trade-off is that the uncovered half of the tent is directly on the ground, so you'll need to be more mindful of moisture and debris in that area. Pair the half floor with a ground cloth or footprint if you expect wet or muddy conditions.
Material and durability notes
The Yukon 8P Half Floor is made from 30D nylon fabric that is waterproof and durable for typical backcountry use. This material is lightweight and packs small, but it is not as puncture-resistant as heavier denier fabrics. Avoid setting up on sharp rocks or sticks without a ground cloth underneath.
Because the half floor is designed to fit inside the Yukon 8P Tent, it uses the tent's existing guyout points for attachment. This means no extra stakes or poles are needed, but you must ensure those points are properly tensioned to keep the floor flat and secure.
How to install and care for your Yukon 8P Half Floor
- 1. Lay out the half floor inside the tent: Unfold the half floor and position it on the side of the tent where you plan to sleep. Make sure it lies flat and covers the intended area without bunching. Common mistake: Trying to install the floor after the tent is fully staked can make it harder to reach the attachment points. Set the floor in place before fully tensioning the tent.
- 2. Attach the floor to the bottom guyout points: Connect the half floor's corner loops to the corresponding guyout points along the tent's base. Start with one corner, then move to the opposite corner to keep tension even. Repeat for the remaining points. Checkpoint: After attaching all points, walk around the tent and verify each connection is snug. Loose corners can let the floor shift or collect debris underneath.
- 3. Smooth and tension the floor: Once attached, pull the floor gently outward to remove wrinkles. Adjust the tent's stake tension if needed to keep the floor flat and prevent pooling of water or dirt. Common mistake: Over-tightening can stress the fabric or pull the tent out of shape. Aim for a flat surface without pulling the floor drum-tight.
- 4. Clean the floor after each trip: Shake off loose dirt and debris before packing. For mud or stains, rinse with cool water and a mild soap (avoid harsh detergents). Let the floor air-dry completely before storing to prevent mildew. Checkpoint: Never machine wash or dry the half floor. The 30D nylon fabric can be damaged by agitation or high heat.
- 5. Store the floor dry and loosely rolled: Fold or roll the half floor without tight creases, and keep it in a breathable storage bag away from direct sunlight. Avoid storing it compressed under heavy gear for long periods. Common mistake: Storing the floor while damp or tightly rolled can cause permanent creases and mildew spots. Always dry thoroughly before packing away.
Product details
- Yukon 8P Half Floor: The Argali Yukon 8P Half Floor is made from a durable waterproof 30D nylon fabric and connects to the bottom guyout points along the Yukon 8P Tent. This makes setup fast and tool-free, while the waterproof fabric keeps your sleeping area dry in wet conditions.
Yukon 8P Half Floor
